Dualsky SUMMIT 30X 6V SBEC ESC
Description
The new Dualsky SUMMIT 30X 6V SBEC ESC is the latest 30A speed control from this excellent manufacturer. This version has a metal heatsink to improve the heat transfer and current capacity. This speed control works flawlessly with all brushless motors, not just Dualsky motors.
The speed control is supplied with the brake ON, so no programming is required for glider use. Solder the brushless motor wires directly to the three PCB lands. Swap any two wires to reverse the direction.
See the photos for the full specifications.
The speed control is supplied with the brake ON, so no programming is required for glider use. Solder the brushless motor wires directly to the three PCB lands. Swap any two wires to reverse the direction.
| Dualsky Summit 30X 6V SBEC ESC Specification | |
|---|---|
| Continuous current | 30A |
| Burst current | 45A |
| Battery | 2S - 6S LiPo |
| SBEC | 3A @ 6V, 6A peak |
| Weight inc leads | 24g |
| Firmware | BLHeli-32 |
| Programmable | Yes, with an Arduino or our BLHELI-USBprog interface |
| PCB Size | 47mm * 17mm |
| Battery connector | 8 cm wires, XT30M plug fitted |
| Motor connector | None (lands on PCB) |
| RC wire length | 12 cm |
| Telemetry | Yes |
See the photos for the full specifications.
Reviews 1
Sir Bob
UK
Nice little ECU especially small for 30amp.
I’ve actually had 3 of these. One for me and the others two were fitted to models I’ve built for other people. They work really well and the 6 volt output is a good compromise if you are using HV servos. I did find one problem. If you are using a 2 cell setup, I found the motor would not start reliably. I discussed this with Neil and he suggested that the minimum voltage be reprogrammed to 2.7 volts per cell. I sent the units back to him and he adjusted them accordingly and now that problem has gone away. They were returned promptly. The issue did not occur when using 3 cells.
I haven’t tried the telemetry yet but will will see how that goes. They appear very well made.
