Pulley For KST X08 & X06 Servos (4)
Description
To secure the pull wire, wrap the wire around the centre screw and then tighten it well.
4 pulleys supplied in each pack, enough for two discus launched gliders.
Reviews 16
Excellent solution for DLG. Well made and a perfect fit on the KST 06 Servo.
N.B They have a top and bottom. You could be forgiven for thinking they don't fit until you realise which is the splined side! There is also a very tiny gap between the underside and the servo so although it looks like they will rub, they don't. Recommended and will buy again.
Rapid despatch and well packed by Hyper Flight as always.
I failed to fit them on the X06, pulley hole seems too small, I’m force to stick with the provided servo horn
However they look neat…
Fast shipping
Nice items and well made. It would be good if yhey came in different diameters as these are small and you would struggle to get enough movement if the model has long control horns, especially on rudder wher you need lots of travel. They also dont work where the servo is installed flat against the fuselage side because the bottom of the pulley 'protrudes' past the bottom face of the servo at full travel.
I wish I had known about these some time back, they're perfect 🙂
These work really will. I wished they did a slightly larger diameter version. Another 2mm version would be good for me.
These work really will. I wished they did a slightly larger diameter version. Another 2mm version would be good for me.
An excellent product, fitted them on the Kst X06 just bought and also to X08 on a refurbished Xxlite dlg. Makes for an easy setting of pull wire, recommend them fully! Would be nice to have these for other servos, too.
Pretty good (though a bit of a luxury item!) - used these on DLG rudder and elevator. Results in more linear movement - and more slightly movement than you'd get with an equivalent arm. I was unsure what the intended method of securing the pull string is - so I take it around the back of the pulley, up through one of the holes and then wrap it around the servo screw before adjusting and tightening.
These look fine only if I know how to secure them with wire. Does anyone have some sort of instructions?
Exactly as described works well with pull cords.
Fast well packaged
Excellent product. Quality nylon. I've purchased a number of items from Hyperflight now (including a Snipe2) and I've been very impressed with the quality of shipping and the postage times. To Australia. Brilliant.
